Probe Coaxial Cable

The3015/ 3018/3011/3025 series transducer probes apply the brand new design to let this probe with long service life, more stable and more reliable output. The newly specially made co?axial cable applies sealed and anti-pull design to prevent the leakage of oil or other liquid to the outside from the inside of cable and can bear 300N tensile force. The gold plated copper connect enable the probe to connect cable in a firmer way and can ensure functions and stability of the transmission system and stable operation in severe environment. and are designed to offer full API 670 compliance when used with a matching 3081 extension cable and a 3082 driver or a KM550/KM550 transmitter. 3015/ 3018 /3011 probes are fully interchangeable with Bently Nevada (BN)4, 3300 and 3300XL 5mm/8mmprobes. Proximity Transducer System Proximity Transducer System Eddy current transducer can either conduct dynamic measurement or static measurement.It is mainly used for vibration and displacement measurement and key-phase and rotating speed measurement for oil-film bearing machinery.The eddy current system can conduct continuous monitoring for rotating shaft's rotating state or rotor's mechanical problems of,e.g.imbalance,de-centering,bearing wear or shaft cracks, etc.,to provide critical information for early determination.The 3015/3018/3011/3025 series transducers apply the advanced design concept and are characterized by wide measurement range,high sensitivity and resolution,quick response speed,strong anti-interference,free of media influence,e.g.grease,etc.,simple structure,etc.It meets the API(API670)standard.In addition,the eddy current probe,extended cable and proximitor have reliable interchangeability;the 5m or 9m monitoring system composed of the transducer, proximitor and extended cable is widely applied in the vibration state monitoring and fault diagnosis of large rotary machinery.   How it works The tip of the eddy probe contains an encapsulated wire coil that radiates the driver's high frequency signal into the observed target as a magnetic field.The driver outputs a DC voltage representing the field strength.As a conductive surface approaches the coil,eddy currents are generated on the target surface,which decreases the field's strength,resulting in a decrease of the driver's DC output.The driver linearizes and normalizes its output to a specific sensitivity, usually 7,87 mV/um(200 mV/mil),throughout its working range.The signal's DC bias,representing the average probe gap,and its AC component,profiling surface movement and irregularities,is readily used in many applications,some of which are shown in the following diagrams.   The3015/ 3018/3011/3025 series transducer probes apply the brand new design to let this probe with long service life, more stable and more reliable output. The newly specially made co?axial cable applies sealed and anti-pull design to prevent the leakage of oil or other liquid to the outside from the inside of cable and can bear 300N tensile force. The gold plated copper connect enable the probe to connect cable in a firmer way and can ensure functions and stability of the transmission system and stable operation in severe environment. and are designed to offer full API 670 compliance when used with a matching 3081 extension cable and a 3082 driver or a KM550/KM550 transmitter. 3015/ 3018 /3011 probes are fully interchangeable with Bently Nevada (BN)4, 3300 and 3300XL 5mm/8mmprobes.